Honeywell Honeywell Security | Protect What Matters Most Betriebsanweisung

Seite von 80
– 70 – 
Regulatory Agency Statements 
 
 
 
 
Federal Communications Commission (FCC) Part 15 
The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's 
Manual.  Unauthorized changes or modifications could void the user's authority to operate the equipment. 
CLASS B DIGITAL DEVICE STATEMENT 
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the 
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. 
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not 
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the 
following measures: 
• 
Reorient or relocate the receiving antenna. 
• 
Increase the separation between the equipment and receiver. 
• 
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 
• 
Consult the dealer or an experienced radio/TV technician for help. 
This Class B digital apparatus complies with Canadian ICES-003. 
Cet appareil num
é
rique de la classe B est conforme 
à
 la norme NMB-003 du Canada.
 
Industry Canada (IC)  
This device complies with RSS210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may 
not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause 
undesired operation. 
Cet appareil est conforme 
à
 la partie 15 des r
è
gles de la FCC & de RSS 210 des Industries Canada. Son fonctionnement est 
soumis aux conditions suivantes: (1) Cet appareil ne doit pas causer d' interferences nuisibles. (2) Cet appareil doit accepter toute 
interference re
ç
ue y compris les interferences causant une reception ind
é
sirable.