Zanussi ZGG96624XA Benutzerhandbuch

In the absence of electricity you can

ignite the burner without electrical

device; in this case approach the

burner with a flame, turn the control

knob counter-clockwise to maximum

gas supply position and push it

down. Keep the control knob

pushed for equal or less than 10

seconds to let the thermocouple

warm up.

If the burner accidentally goes out,

turn the control knob to the off

position and try to light the burner

again after minimum 1 minute.

The spark generator can start

automatically when you switch on

the mains, after installation or a

power cut. It is normal.

To put the flame out, turn the knob to the off
position  .

Always turn the flame down or

switch it off before you remove the

pans from the burner.

Refer to Safety chapters.

Do not use cast iron pans,

potstones, earthenware, grill or

toaster plates. The stainless steel

can become tarnished if it is too

much heated.

Do not put the same pan on two

burners.

Do not put unstable or damaged

pots on the burner to prevent from

spill and injury.

Make sure that the bottoms of pots

do not stand above the control knob,

otherwise the flame heats the

control knob up.

Make sure that pot handles are not

above the front edge of the cooktop.

Make sure that the pots are placed

centrally on the burner in order to

get maximum stability and to get

lower gas consumption.

Use cookware with diameters

applicable to the size of burners.

Triple Crown

180 - 260

Rapid

180 - 260

Semi-rapid

120 - 220

Auxiliary

80 - 160

Refer to Safety chapters.

• Clean the hob after each use.

• Always use cookware with clean bottom.

• Scratches or dark stains on the surface have

no effect on how the hob operates.

• Use a special cleaner applicable for the

surface of the hob.