Zanussi ZDI22001XA Benutzerhandbuch

You cannot activate the appliance.

• Make sure that the mains plug is connected to the mains

socket.

• Make sure that there is no a damage fuse in the fuse box.

The programme does not start.

• Make sure that the appliance door is closed.

• Press Start.

• If the delay start is set, cancel the setting or wait for the

end of the countdown.

• The appliance has started the procedure to recharge the

resin inside the water softener. The duration of the proce-

dure is approximately 5 minutes.

The appliance does not fill with wa-

ter.
• The indicator 

 flashes 1 time

intermittently.

• The indicator   flashes continu-

ously.

• Make sure that the water tap is open.

• Make sure that the pressure of the water supply is not too

low. For this information, contact your local water authority.

• Make sure that the water tap is not clogged.

• Make sure that the filter in the inlet hose is not clogged.

• Make sure that the inlet hose has no kinks or bends.

The appliance does not drain the

water.
• The indicator 

 flashes 2

times intermittently.

• The indicator   flashes continu-

ously.

• Make sure that the sink spigot is not clogged.

• Make sure that the drain hose has no kinks or bends.

The anti-flood device is on.
• The indicator 

 flashes 3

times intermittently.

• The indicator   flashes continu-

ously.

• Close the water tap and contact the Service.

Once you have checked the appliance, press   . If

the problem occurs again, contact the Service.

For alarm codes not described in the table, contact

the Service.

There are whitish streaks or blu-

ish layers on glasses and dishes.

• The release quantity of rinse aid is too much. Adjust the rinse

aid selector to a lower position.

• The quantity of detergent is too much.

There are stains and dry water

drops on glasses and dishes.

• The released quantity of rinse aid is not sufficient. Adjust the

rinse aid selector to a higher position.

• The quality of the rinse aid can be the cause.