Zanussi ZWI71209WA Benutzerhandbuch

WATER INLET
• The inlet hose is supplied with the appliance

and can been found inside the appliance drum.

• Do not use the hose from your previous

appliance to connect to the water supply.

This appliance must be connected toa

cold water supply.

45˚

35˚

• Connect the hose

with the angled con-

nection to the ma-

chine. Do not place

the inlet hose down-

wards.

• Angle the hose to the

left or right depending

on the position of your

water tap.

• Set the hose correctly by loosening the ring nut.

After positioning the inlet hose, be sure to tight-

en the ring nut again to prevent leaks.

• Connect the hose to a

tap with a 3/4”thread.

Always use the hose

supplied with the ap-

pliance.

• The inlet hose must not be lengthened. If it is

too short and you do not wish to move the tap,

you will have to purchase a new, longer hose

specially designed for this type of use.

WATER DRAINAGE
The end of the drain hose can be positioned in

three ways:

• Hooked over the edge of a sink using the

In this case, make sure the end cannot come

unhooked when the appliance is emptying. This

could be done by tying it to the tap with a piece

of string or attaching it to the wall.

• In a sink drain pipe branch.

This branch must be above the trap so that the

bend is at least 60 cm above the ground.

• Directly into a drain pipe at a height of not

less than 60 cm and not more than 90 cm.

The end of the drain hose must always be

ventilated, i.e. the inside diameter of the

drainpipe must be larger than the outside

diameter of the drain hose. The drain hose must

not be kinked.

The drain hose may be extended to a maximum of 4

metres. An additional drain hose and joining piece

is available from your local Service Centre