Cisco Cisco 1-Port DOCSIS-based Cable High-speed WAN Interface Card (HWIC) Fehlerbehebungsanleitung
Troubleshooting Router Interfaces and Modules
Issues
Issues
Document ID: 71820
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Background Information
Basic Troubleshooting Steps
Modules Not Recognized
Routers and Supported Modules
Advanced Integration Modules
AIM Slots Clock Source Issues
AIM−VPN/SSL Not Recognised
IMA Minimum Link Not Working
IMA Interface Flaps
Multiflex Trunk Voice and WAN Interface Cards
VWIC−1MFT−T1, VWIC−2MFT−T1 Hardware Installation
VWIC2−1MFT−T1/E1, VWIC2−2MFT−T1/E1 Hardware Installation
LCV and PCV Errors
Network Modules
Prerequisites
Requirements
Components Used
Conventions
Background Information
Basic Troubleshooting Steps
Modules Not Recognized
Routers and Supported Modules
Advanced Integration Modules
AIM Slots Clock Source Issues
AIM−VPN/SSL Not Recognised
IMA Minimum Link Not Working
IMA Interface Flaps
Multiflex Trunk Voice and WAN Interface Cards
VWIC−1MFT−T1, VWIC−2MFT−T1 Hardware Installation
VWIC2−1MFT−T1/E1, VWIC2−2MFT−T1/E1 Hardware Installation
LCV and PCV Errors
Network Modules
NM−1T3/E3 Installation Issues (DS3 Card)
Ethernet Switching Network Modules
Inline Power Issues
Troubleshooting Serial Interfaces
Related Information
Ethernet Switching Network Modules
Inline Power Issues
Troubleshooting Serial Interfaces
Related Information
Introduction
This document helps troubleshoot router interfaces and modules. The document also discusses the causes of
the problems, as well as basic procedures to troubleshoot, identify, and solve the problems.
the problems, as well as basic procedures to troubleshoot, identify, and solve the problems.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on the Cisco 2600, 2800, 3600, 3700, 3800, and 7200 Series
routers.
routers.
The information in this document was created from the devices in a specific lab environment. All the devices
used in this document started with a cleared (default) configuration. If your network is live, make sure that
used in this document started with a cleared (default) configuration. If your network is live, make sure that