Cisco Cisco Clean Access 3.5
4-41
Cisco Clean Access Manager Installation and Administration Guide
OL-7044-01
Chapter 4 Switch Management and Cisco Clean Access Out-of-Band (OOB)
Configure OOB Switch Management in the CAM
Config Tab
The Config tab allows you to modify Basic, Advanced, and Group profile settings for a particular switch.
Basic
The Basic tab shows the following values configured for the switch.
Figure 4-25
Basic Config
•
The first values come from the initial configuration done on the switch itself:
–
IP Address
–
MAC Address
–
Location
–
Contact
–
System Info (translated from the MIB for the switch)
•
Switch Profile — Shows the Switch Profile you are using for this Switch configured under Switch
Management > Profiles > Switch. The Switch Profile sets the model type, the SNMP port on which
to send SNMP traps, SNMP version for read and write and corresponding community strings, or
authentication parameters (SNMP V3 Write).
Management > Profiles > Switch. The Switch Profile sets the model type, the SNMP port on which
to send SNMP traps, SNMP version for read and write and corresponding community strings, or
authentication parameters (SNMP V3 Write).
•
Default Port Profile — Shows the default Port profile applied to unconfigured ports on the switch
on the Ports tab. The “uncontrolled” port profile is the initial default profile for all ports, unless you
change the setting here.
on the Ports tab. The “uncontrolled” port profile is the initial default profile for all ports, unless you
change the setting here.
•
Description—Optional description of the switch.