Cisco Cisco Clean Access 3.5
11-5
Cisco Clean Access Manager Installation and Administration Guide
OL-7044-01
Chapter 11 Clean Access Agent
Enable Clean Access Agent for L3 Deployments
Enable L3 Support for Clean Access Agent
1.
Go to Device Management > CCA Servers > List of Servers and click the Manage button (
) for
the CAS. The management pages for the Clean Access Server appear.
2.
Click the Network tab. The IP form appears by default.
Figure 11-1
CAS Network Tab
3.
The Clean Access Server Type should display the Server Type selected when the CAS was added
to the CAM.
to the CAM.
4.
Click the checkbox for Enable L3 Support for Clean Access Agent.
5.
The Trusted Interface and Untrusted Interface settings should match the configuration
parameters given during the installation or your configured settings.
parameters given during the installation or your configured settings.
6.
Click Update.
7.
Click Reboot.
8.
Make sure the Discovery Host field is correct under Device Management > Clean Access > Clean
Access Agent > Distribution.
Access Agent > Distribution.
Note
•
The enable/disable L3 feature is new for release 3.5(5) and is disabled by default. You must Update
and Reboot for changes in this setting to take effect.
and Reboot for changes in this setting to take effect.
•
L3 must be enabled for the Clean Access Agent to work with VPN tunnel mode.