Cisco Cisco IPS 4255 Sensor Technisches Handbuch
Configuring IPS TCP Reset Using IME
Document ID: 44903
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Configure
Network Diagram
Configurations
Start the Sensor Configuration
Add the Sensor into the IME
Configure the TCP Reset for the Cisco IOS Router
Verify
Launch the Attack and the TCP Reset
Troubleshoot
Tips
Related Information
Prerequisites
Requirements
Components Used
Conventions
Configure
Network Diagram
Configurations
Start the Sensor Configuration
Add the Sensor into the IME
Configure the TCP Reset for the Cisco IOS Router
Verify
Launch the Attack and the TCP Reset
Troubleshoot
Tips
Related Information
Introduction
This document discusses the configuration of the Intrusion Prevention System (IPS) TCP Reset using the IPS
Manager Express (IME). IME and IPS Sensors are used to manage a Cisco router for TCP Reset. When you
review this configuration, remember these items:
Manager Express (IME). IME and IPS Sensors are used to manage a Cisco router for TCP Reset. When you
review this configuration, remember these items:
Install the Sensor and make sure the Sensor works properly.
•
Make the sniffing interface span to the router outside the interface.
•
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on these software and hardware versions:
Cisco IPS Manager Express 7.0
•
Cisco IPS Sensor 7.0(0.88)E3
•
Cisco IOS® router with Cisco IOS Software Release 12.4
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.