Cisco Cisco Web Security Appliance S670 Fehlerbehebungsanleitung
Ensure Proper Virtual WSA HA Group
Functionality in a VMware Environment
Functionality in a VMware Environment
Document ID: 119188
Contributed by Ana Peric and Ivo Sabev, Cisco TAC Engineers.
Jul 30, 2015
Jul 30, 2015
Contents
Introduction
Prerequisites
Requirements
Components Used
Problem
Problem Analysis
Solution
Modify the Net.ReversePathFwdCheckPromisc Option
Related Information
Prerequisites
Requirements
Components Used
Problem
Problem Analysis
Solution
Modify the Net.ReversePathFwdCheckPromisc Option
Related Information
Introduction
This document describes the process that must be completed so that the Cisco Web Security Appliance
(WSA) High Availability (HA) feature works properly on a Virtual WSA that runs in a VMware environment.
(WSA) High Availability (HA) feature works properly on a Virtual WSA that runs in a VMware environment.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Cisco WSA
•
HTTP
•
Multicast traffic
•
Common Address Resolution Protocol (CARP)
•
Components Used
The information in this document is based on these software and hardware versions:
AsyncOS for Web Version 8.5 or later
•
VMware ESXi Version 4.0 or later
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.