Cisco Cisco ONS 15454 SDH Multiservice Provisioning Platform (MSPP) Installationsanleitung

Weight not including clam shell: 0.2 kg (0.5 lbs.) 

Compliance

ONS 15454 SDH cards, when installed in a system, comply with these standards: 

Safety: IEC 60950, EN 60950, UL 60950, CSA C22.2 No. 60950, TS 001, AS/NZS 3260

Use this section if you are installing or removing the MIC-A/P card for the first time. After you become 
familiar with ONS 15454 SDH card installation and boot up, use this section as a reference. 

Always use the supplied electrostatic discharge (ESD) wristband when working with an ONS 15454 
SDH. Plug the wristband cable into the ESD jack located on the lower right outside edge of the shelf 
assembly and ensure the shelf assembly is properly grounded.

Hazardous voltage or energy may be present on the backplane when the system is operating. Use caution 
when servicing. 

Carefully insert the card into the rails of slot 23 (

Move the upper ejector down and the lower ejector up to enable the card being inserted into the 
backplane connectors. 

Gently push the card into the connector on the back plane. 

Tighten the front mounting screws with a Phillips or slot screwdriver. 

MIC-A/P cards have electrical plugs that plug into electrical connectors on the shelf assembly 
backplane. When the ejectors are fully closed and the mounting screws are tightened, the card plugs into 
the shelf assembly backplane. 

 shows general card installation. Connecting the power 

cable is described in Chapter 1 “Installation” of the Cisco ONS 15454 SDH Installation and Operations 
Guide.