Cisco Cisco Wireless Services Module 2 (WiSM2) Technisches Handbuch
Central Web Authentication with FlexConnect APs
on a WLC with ISE Configuration Example
on a WLC with ISE Configuration Example
Document ID: 116087
Contributed by Nicolas Darchis, Cisco TAC Engineer.
Feb 19, 2015
Feb 19, 2015
Contents
Introduction
Prerequisites
Requirements
Components Used
Configure
Network Diagram
WLC Configuration
ISE Configuration
Create the Authorization Profile
Create an Authentication Rule
Create an Authorization Rule
Enable the IP Renewal (Optional)
Traffic flow
Verify
Prerequisites
Requirements
Components Used
Configure
Network Diagram
WLC Configuration
ISE Configuration
Create the Authorization Profile
Create an Authentication Rule
Create an Authorization Rule
Enable the IP Renewal (Optional)
Traffic flow
Verify
Introduction
This document describes how to configure central web authentication with FlexConnect Access Points (APs)
on a Wireless LAN Controller (WLC) with Identity Services Engine (ISE) in local switching mode.
on a Wireless LAN Controller (WLC) with Identity Services Engine (ISE) in local switching mode.
Important Note: At this time, local authentication on the FlexAPs is not supported for this scenario.
Other Documents in this Series
Central Web Authentication with a Switch and Identity Services Engine Configuration Example
•
Central Web Authentication on the WLC and ISE Configuration Example
•
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on these software and hardware versions:
Cisco Identity Services Engine (ISE), Release 1.2.1
•
Wireless LAN Controller Software, Release Version − 7.4.100.0
•