Cisco Cisco Catalyst 6500 Series Intrusion Detection System (IDSM-2) Module Fehlerbehebungsanleitung
Products & Services
Integrate Cisco Service Modules with Cisco Catalyst 6500
Virtual Switching System 1440
Document ID: 109550
Introduction
This document explains how to integrate various Cisco Service modules (supported
by Cisco Catalyst 6500 series switches) with the Cisco Catalyst 6500 Virtual
Switching System 1440.
by Cisco Catalyst 6500 series switches) with the Cisco Catalyst 6500 Virtual
Switching System 1440.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Knowledge of Virtual Switching Systems (VSS) concepts. For more information,
refer to
refer to
Understanding Virtual Switching Systems
. There is a brief description of VSS
in this document, but it is not meant to be a comprehensive explanation.
Components Used
The information in this document is based on these software and hardware versions:
Cisco Catalyst 6500 Virtual Switching System 1440 that runs Cisco IOS®
Software Release 12.2(33)SXI or later
Software Release 12.2(33)SXI or later
See the
Table
of the
Service Module Integration
section.
The information in this document was created from the devices in a specific lab
environment. If your network is live, make sure that you understand the potential
impact of any command.
environment. If your network is live, make sure that you understand the potential
impact of any command.
Conventions
Refer to
Cisco Technical Tips Conventions
for more information on document
conventions.
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Background Information
Service Module Integration
Redundancy with Service Modules
Application Control Engine (ACE) and Firewall Service Module
(FWSM)
Wireless Services Module (WiSM)
Intrusion Detection System Services Module (IDSM-2)
Summary
Cisco Support Community - Featured Conversations
Related Information