Cisco Cisco Packet Data Gateway (PDG) Installationsanleitung
Applying Power and Verifying the Installation
Verifying the Installation ▀
ASR 5000 Installation Guide ▄
175
Figure 55. Card-Level Status LEDs for the Optical (ATM) Line Card
Optical (ATM) Line Card Run/Fail LED States
The Run/Fail LED on the ATM line card indicates the overall status of the card. These LEDs are illuminated steady
green for normal operation.
green for normal operation.
If the LED is not green, use the troubleshooting information in the table to diagnose the problem.
Table 69.
Optical (ATM) Line Card Run/Fail LED States
Color
Description
Troubleshooting
Green Card powered with no errors detected
None needed.
Red
Card powered with error(s) detected
Errors were detected during the POSTs. It is likely that the errors were
logged to the system's command line interface during the boot process.
Refer to the System Administration Guide for troubleshooting information.
logged to the system's command line interface during the boot process.
Refer to the System Administration Guide for troubleshooting information.
None
Card is not receiving power
Verify that the power source is supplying ample voltage and current to the
chassis.
chassis.
Verify that the card is properly installed per the instructions in this
document.
document.
If all of the above suggestions have been verified, it is possible that the line
card is not functional. Please contact your service representative.
card is not functional. Please contact your service representative.