Cisco Cisco Packet Data Gateway (PDG) Installationsanleitung
Technical Specifications
Interface Specifications ▀
ASR 5000 Installation Guide ▄
263
Interface Specifications
The table below lists the line card interfaces for use within the chassis.
Table 88.
Line Card Interfaces
Card Type
Port
Quantity
Connector Type
Notes
SPIO
Console
1
RJ-45, RS-232 serial
—
Console Cable Assembly
1
RJ-45 to DB-9
—
Gigabit Ethernet
2
Optical SFP
—
10/100 Mbps
2
RJ-45, Ethernet
1
CO Alarm
1
10-pin, Molex
—
CO Alarm cable Assembly
1
Dual 10-pin Molex to barrier terminal
—
BITS BNC (optional)
1
BNC, coaxial cable
2
BITS 3-Pin (optional)
3-pin, wire-wrap
FLC2
10/100 Ethernet
8
RJ-45, Ethernet
1
GLC2
Gigabit Ethernet
1
SFP-SX
3
SFP-LX
SFP-T, copper RJ-45
QGLC
Gigabit Ethernet
4
SFP-SX
4
SFP-LX
SFP-T, copper RJ-45
XGLC
10 Gigabit Ethernet
1
10GBase-SR, SFP+
5
10GBase-LR, SFP+
OLC2
ATM/POS OC-3 SM IR-1
1
Single-mode Fiber, LC duplex
—
ATM/POS OC-3 Multi-Mode
Multi-mode Fiber, LC duplex
CLC2
Channelized (STM-1/OC-3) SM IR-1
1
Single-mode Fiber, LC duplex
—
Channelized (STM-1/OC-3)Multi-Mode
Multi-mode Fiber, LC duplex
Notes
1. An RJ-45 Ethernet interface may have more than one pin-out configuration, depending on the type of cable used.
2. An SPIO may be equipped with one type of BITS connector – BNC or 3-pin.
3. A Small Form-factor Pluggable transceiver is supplied with the GLC2 based on the customer-specified interface
2. An SPIO may be equipped with one type of BITS connector – BNC or 3-pin.
3. A Small Form-factor Pluggable transceiver is supplied with the GLC2 based on the customer-specified interface
type.
4. Four Small Form-factor Pluggable transceivers are supplied with the QGLC based on the customer-specified
interface type.
5. An enhanced SFP (SFP+) transceiver is supplied with the XGLC based on the customer-specified interface type.