Cisco Cisco Packet Data Gateway (PDG) Installationsanleitung
Technical Specifications
▀ Interface Specifications
▄ ASR 5000 Installation Guide
272
1000Base-LX Interface
The 1000Base-LX fiber SFP interface on the Ethernet 1000 LX line card has one pair of host connectors. The QGLC
has four pairs.
has four pairs.
Table 98.
1000Base-LX Fiber Transmit and Receive Levels
Signal
Level
Max TX: 0 dBm
Min TX:
-9.5 dBm
Max RX: 0 dBm (saturation average power)
Min RX: -20 (typical) / -19 (max.) dBm (sensitivity average power)
1000Base-T
The 1000Base-T SFP copper interfaces on the GLC2 and QGLC line cards require unshielded twisted pair (UTP)
copper CAT-5 cable with a bit error rate (BER) less than 10e-10. Pinouts for the RJ-45 Ethernet ports are shown in the
table below.
copper CAT-5 cable with a bit error rate (BER) less than 10e-10. Pinouts for the RJ-45 Ethernet ports are shown in the
table below.
Table 99.
1000Base-T RJ-45 Ethernet Copper Pinouts
Pin
1000Base-Tx 1Gbps Cat5+
1
BI DA+
2
BI DA-
3
BI DB+
4
BI DC+
5
BI DC-
6
BI DB-
7
BI DD+
8
BI DD-
RX = Receive Data TX = Transmit Data BI = BI directional data DA,
DB, DC, DD = Data Pair A, B, C, and D
DB, DC, DD = Data Pair A, B, C, and D