Cisco Cisco ASR 1000 Series Route Processor (RP2) Datenbogen

Seite von 9
 
 
Cisco Systems, Inc.  
All contents are Copyright © 1992–2004 Cisco Systems, Inc. All rights reserved. Important Notices and Privacy Statement. 
Page 3 of 9 
 
 
 
256-MB packet buffer 
 
2 MB of NVRAM 
 
1 GB of DRAM 
 
Support for route-processor main memory error checking and correction (ECC)  
 
One Ethernet 10-/100-Mbps network management interface with an RJ-45 connector 
 
Serial console port 
 
Auxiliary (modem) port 
 
Alarm contacts (critical, major, and minor) 
 
Push-button reset 
CISCO PXF HARDWARE FEATURES 
 
Four Cisco PXF network processors (containing a total of 64 individual processors) 
 
Two independent 32-MB synchronous dynamic RAM (SDRAM) control memories on each processor set 
 
Cisco PXF configuration memory (per column): 128 MB  
 
Cisco PXF configuration memory (total): 1 GB  
 
Support for Cisco PXF column memory ECC 
 
Support for Cisco PXF packet buffer memory ECC 
 
Backplane interconnect application-specific integrated circuit (ASIC) for buffer management, flow control, management to the network 
processor, and interface to the Cisco uBR10012 backplane 
SOFTWARE FEATURES 
With Cisco PXF, the Cisco PRE-2 separates control-plane functions from data-plane functions. A general-purpose RISC processor (500 MHz 
RM7000 mips) supports control-plane functions of administration, route processing, management, and configuration. Multiple Cisco PXF 
network processors support data-plane functions—including high-performance Layer 3 forwarding. The combination of a general-purpose 
RISC processor with advanced programmable Cisco PXF network processors provides maximum flexibility while maintaining maximum 
throughput of essential IP services such as quality of service (QoS), Multiprotocol Label Switching (MPLS), and access policy filtering.  
HIGH-AVAILABILITY FEATURES 
 
Online insertion and removal (OIR) 
 
Cisco IOS
®
 Software Route Processor Redundancy Plus (RPR+) 
 
Hot Standby Connection-to-Connection Protocol (HCCP); N + 1 RF line-card redundancy and RF switch management