Cisco Cisco Packet Data Gateway (PDG)

 

 

 

QCI-QOS mapping table 

If configured, the name of the QCI-QOS mapping table associated with this APN Profile. 

Location Reporting 

Location Reporting UMTS 

Indiates the configuration of the 

 command for UMTS access type. 

Location Reporting GPRS 

Indiates the configuration of the 

 command for GPRS access type. 

APN Type

 

Indicates the configuration of the 

 command, which identifies the APN is an IMS 

APN, allowing the SGSN to delay sending MBR to the S-GW until after receiving the Forward 
Relocation Complete Ack from the peer during SRNS procedure. By default this identification 
is disabled. 

QOS upgrade from PGW for non-gbr 

Action 

Indicates the configuration of the 

 command, which configures 

the action to be taken when the MME receives a QoS upgrade from P-GW for Non-GBR 
bearers 
Possible values: accept/reject/locally-cap/Not Configured. 

Dedicated bearers 

GBR 

Indicates the configuration of the 

 command, which configures the 

MME to either accept or reject GBR dedicated bearers.  
Possible values: accept/reject/Not Configured. 

Non-GBR 

Indicates the configuration of the 

 command, which configures the 

MME to either accept or reject Non-GBR dedicated bearers.  
Possible values: accept/reject/Not Configured. 

Allow QoS Upgrade from GGSN 

QoS Upgrade From GGSN 
(UMTS)  

Indicates if QoS upgrade from GGSN is enabled or disabled. 

Capped with Subscribed QoS  

Indicates if capping of QoS with Subscribed QoS (local/HLR) is enabled or disabled. 

QoS Upgrade From GGSN 
(GPRS)  

Indicates if QoS upgrade from GGSN is enabled or disabled. 

Capped with Subscribed QoS  

Indicates if capping of QoS with Subscribed QoS (local/HLR) is enabled or disabled. 

Bearer Inactivity Timeout 

Exclude Default Bearer 

Indicates if the application will ignore bearer inactivity handling for default/primary bearer. 

GBR or non-GBR 

Indicates that the system will check for low activity on a GBR or non-GBR bearer.  

Timeout (Seconds) 

The configured dedicated bearer timeout, in seconds. 

Threshold (bytes) 

The configured volume threshold for the dedicated bearer timeout (in bytes). 

Direction 

The traffic direction on which to execute the dedicated bearer timeout action (uplink, downlink, 
or bi-directional). 

Associated Quality of Service 
Profile Name (UMTS)  

Displays the name of the Quality of Service profile associated with the APN profile in a 3G 
network (access type “UMTS”). 

Associated Quality of Service 
Profile Name (GPRS) 

Displays the name of the Quality of Service profile associated with the APN profile in a 2G 
network (access type “GPRS”).