Cisco Cisco Packet Data Gateway (PDG)

 

 

 

Uplink traffic-policing 

Indicates if traffic policing is enabled for the uplink direction. 

Downlink traffic-shaping 

Indicates if traffic shaping is enabled for downlink direction. 

Uplink traffic-shaping 

Indicates if traffic shaping is enabled for uplink direction. 

Radius Accounting Mode 

Indicates if the RADIUS accounting mode is either session-based or access-flow-based. 

cscf-service name 

The CSCF service name. 

cscf registration AoR 

The CSCF registered AoR. 

apn 

The Access Point Name associated with the subscriber.  

nsapi 

The subscriber’s Network Service Access Point Identifier (NSAPI).  

imsi 

The subscriber’s International mobile Subscriber Identity. 

MSISDN 

The Mobile Station International ISDN Number (MSISDN) of the subscriber node. 

remote-ip-addr 

The assigned remote IP address. 

imei(sv) 

The UE’s MAC address with FFFE appended at the end. 

uli 

Displays the access point’s identity. 

mcc 

The Mobile Country Code. 

mnc 

The Mobile Network Code. 

lac 

The Location Area Code, which identifies a location area. 

ci 

The Cell ID, which identifies a cell within a location area. 

input pkts 

Indicates the number of packets received. 

output pkts 

Indicates the number of packets transmitted. 

input bytes 

Indicates the number of bytes received. 

output bytes 

Indicates the number of bytes transmitted. 

input bytes dropped 

Indicates the number of bytes that were dropped while receiving data for this subscriber 
session. 

output bytes dropped 

Indicates the number of bytes that were dropped while transmitting data for this subscriber 
session. 

input pkts dropped 

Indicates the number of packets that were dropped while receiving data for this subscriber 
session. 

output pkts dropped 

Indicates the number of packets that were dropped while transmitting data for this subscriber 
session. 
This field includes packets blocked by Access Control Lists (ACLs). Do not use this figure 
when computing the total number of output packets. 

input pkts dropped due to zero 
mbr 

Indicates the number of packets that were dropped while receiving data due to configured 
maximum bit rate (MBR) was set to zero for a subscriber. 
This counter is applicable when system drops uplink/downlink packets when SGSN notifies 
Update PDP Contexts for QOS change with bandwidth rate as zero for conversation/streaming 
class of services.