Cisco Cisco ONS 15600 SDH Multiservice Provisioning Platform (MSPP) Installationsanleitung

Perform 

 for each node that will be upgraded, moving from the furthest node from the GNE 

toward the GNE itself, which should be activated last.

You might have to log in ( and 

) to each node again to activate the software (

After all nodes have been activated, log in using CTC or Telnet ( and 

) and verify there are no 

outstanding alarms.

Remove all MS-SPRing lockouts using the following TL1 command:

RLS-PROTNSW-<STMN_TYPE>:[<TID>]:<AID>::[::<DIRECTION>]; 

where:

<AID> identifies the facility in the node to which the switch request is directed.

<CTAG> is the correlation tag that correlates command and response messages (optional).

<DIRN> is the direction of transmission (transmit or receive). The possible values are:

RCV—Receive direction only (default)

TRMT—Transmit direction only

BTH—Both transmit and receive directions

For example:

RLS-PROTNSW-STM16:PETALUMA:FAC-6-1:209::BTH;

Use this document in conjunction with the following publications:

Cisco ONS 15600 SDH Procedure Guide
Provides installation, turn up, test, and maintenance procedures

Cisco ONS 15600 SDH Reference Manual
Provides technical reference information for cards, nodes, and networks

Cisco ONS 15600 SDH Troubleshooting Guide
Provides a list of alarms and troubleshooting procedures, general troubleshooting information, and 
hardware replacement procedures

Cisco ONS SDH TL1 Command Guide
Provides a full TL1 command and autonomous message set including parameters, AIDs, conditions 
and modifiers for the Cisco ONS 15454 SDH and ONS 15600 SDH

Cisco ONS SDH TL1 Reference Guide
Provides general information, procedures, and errors for TL1 in the Cisco ONS 15454 SDH and 
ONS 15600 SDH

Release Notes for Cisco ONS 15600 SDH Release 9.1
Provides caveats, closed issues, and new feature and functionality information