Cisco Cisco Catalyst 6500 Series Network Analysis Module (NAM-1 NAM-2) Technisches Handbuch
How To Upgrade the NAM to Version 3.x
Document ID: 43122
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Upgrade the NAM Software to Version 3.x
Task
Step−by−Step Instructions
Verify
Troubleshoot
Related Information
Prerequisites
Requirements
Components Used
Conventions
Upgrade the NAM Software to Version 3.x
Task
Step−by−Step Instructions
Verify
Troubleshoot
Related Information
Introduction
This document provides a step−by−step procedure on how to upgrade Network Analysis Module (NAM)
software to release 3.x.
software to release 3.x.
Prerequisites
Requirements
Ensure that you meet these requirements before you attempt this configuration:
Familiarity with File Transfer Protocol (FTP)
•
Familiarity with Catalyst switch administration from the command line
•
Components Used
The information in this document is based on these software and hardware versions:
WS−X6380 (original NAM)
•
NAM version 3.0 software
•
NAM−1 and NAM−2 hardware devices
•
Catalyst 6505 that runs CatOS 7.3.1
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.