Cisco Cisco VC220 Dome Network Camera Wartungshandbuch

Installing the Cisco VC 220 Camera

VC 220 Dome WDR Day/Night PoE Network Camera Administration Guide

21

Before installing the camera, look for a spot that best suits your needs. The built-in 
PIR sensor is designed to be triggered when a person enters its detection range. 
Therefore, it is crucial to install your camera at a place with the PIR sensor facing 
the desired direction. The sensitivity of the PIR sensor depends on the object size 
and temperature differences between the object and the background 
environment.

Do not install the Cisco VC 220 camera around sources of heat, such as direct 
sunlight, radiators, ovens, or televisions. For more cautions and warnings, see 

.

If you have more than one camera, make a note of the MAC address found on the 
side of the camera. You may want to refer to the MAC address later to identify 
multiple cameras. Your MAC address will be something like the following: 
00:21:29:72:7D:2C.

Use the screwdriver to detach the dome cover from the camera base.

For a ceiling mount, insert the supplied two screws in the corresponding holes on 
each side of the camera base and secure them with a screwdriver. Consider using 
Steps 4 and 5 to make the mount more secure.

For a wall mount, attach the alignment template to the wall.

Drill two pilot holes into the ceiling/wall through the two circles on the template.

I/O

Audio Out

Mic. In

Ext.

Int.

1 

2 

3 

4 

Side view

Top view