Fujifilm FUJIFILM X-A2 Benutzeranleitung

Seite von 152
27
B
a
si
c Ph
o
to
g
ra
p
h
y a
n
d Pl
a
y
b
a
ck
 
 
Using the Flash
Using the Flash
Use the built-in fl ash for additional lighting when shooting at night or indoors under low light.
  1
 Press the 
N button to raise the fl ash.
 
Q The fl ash may contact accessories mounted on the hot shoe.  If necessary, 
remove accessories before raising the fl ash.
  2
 Select 
FLASH MODE in the shooting menu.  The options shown below will 
be displayed; press the selector up or down to highlight an option and press 
MENU/OK to select.
Mode
Mode
Description
Description
AUTO
AUTO  (AUTO FLASH)
(AUTO FLASH)//
K
K  (RED EYE REDUCTION)
(RED EYE REDUCTION)
 *
 *
The fl ash fi res when required.  Recommended in most situations.
N
N  (FORCED FLASH)
(FORCED FLASH)//
L
L  (FORCED FLASH)
(FORCED FLASH)
 *
 *
The fl ash fi res whenever a picture is taken.  Use for backlit subjects or for natu-
ral coloration when shooting in bright light.
O
O  (SLOW SYNCHRO)
(SLOW SYNCHRO)//
M
M  (RED EYE & SLOW)
(RED EYE & SLOW)
 *
 *
Capture both the main subject and the background under low light (note that 
brightly lit scenes may be overexposed).
l
l  (2ND CURTAIN SYNC.)
(2ND CURTAIN SYNC.)//
d
d  (2ND CURTAIN SYNC.)
(2ND CURTAIN SYNC.)
 *
 *
The fl ash fi res immediately before the shutter closes.
D
D (COMMANDER)
 (COMMANDER)
The built-in fl ash can be used to control optional remote fl ash units.
5
P
SHOOTING MENU
OFF
AUTO
OFF
±0
OFF
±0
OFF
FLASH MODE
O
AUTO
FORCED FLASH
SLOW SYNCHRO
2ND CURTAIN SYNC.
COMMANDER
* Red-eye removal is available in these modes when Intelligent Face Detection is active 
(
P 75) and red-eye removal is on (P 77).  Red-eye removal minimizes “red-eye” caused 
when light from the fl ash is refl ected from the subject’s retinas as shown in the illustra-
tion at right.