Cisco Cisco Interface Module for LoRaWAN 868MHz and 915MHz Installationsanleitung

Getting Started and Product Document of Compliance for the Cisco LoRaWAN Interface Module

Pole/Wall Mounting

LEDs

This section describes the LEDs for the Cisco LoRaWAN Interface Module. See 

 for the locations of 

LED indicators.

Pole/Wall Mounting

For more installation options and detailed installation instructions, see the Cisco LoRaWAN Interface Module 

Hardware Installation Guide.

The Cisco LoRaWAN Interface Module can be pole or wall mounted by using the mounting kit (AIR-ACC1530-PMK1=).

 Only trained and qualified personnel should be allowed to install, replace, or service this equipment. 

Statement 1030

 Installation of the equipment must comply with local and national electric codes. Statement 1074

When mounting a Cisco LoRaWAN Interface Module on a horizontal or vertical surface, you must ensure that the device 
is oriented with the LED indicators pointing down (see 

). This positioning allows LEDs to be visible 

to someone on the ground below the device.

You must also ensure the Cisco LoRaWAN Interface Module is mounted in such a way as to ensure that all antenna ports 
and the console port are accessible for future use.

LED

LED Color

Definition

System LED (LED 1)

Off

Power off or under bootloader mode

Blinking green

Under the starting kernel (bring up phase)

Solid green

Normal operation state

Blinking red



Failed to get IP address



Register to IR800 failed

Solid red



ACT2 check failed



Lost connection to IR800



CPU usage high



Temperature high



Flash usage high



Cover open

Reserved LED (LED 2)

Reserved for future use.

—