Cisco Cisco MGX-FRSM-HS2 B Serial Frame Service Module Technisches Handbuch
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Background Information
Register the LAP with the WLC
Layer 2 LWAPP WLC Discovery Algorithm
Layer 3 LWAPP WLC Discovery Algorithm
WLC Selection Process
Troubleshoot
AP Fail-over Between Different Mobility Groups
Related Information
Introduction
This document explains the different methods that lightweight access points (LAPs)
Note: In controller software Release 5.2 or later, Cisco LAPs use the IETF standard Control
and Provisioning of Wireless Access Points (CAPWAP) protocol in order to communicate
between the controller and other LAPs on the network. Controller software releases earlier
than Release 5.2 use the Lightweight Access Point Protocol (LWAPP) for these
communications, which is covered in this document. See
and Provisioning of Wireless Access Points (CAPWAP) protocol in order to communicate
between the controller and other LAPs on the network. Controller software releases earlier
than Release 5.2 use the Lightweight Access Point Protocol (LWAPP) for these
communications, which is covered in this document. See
for AP registration and how to troubleshoot with
the CAPWAP protocol.
Prerequisites
Requirements
Ensure that you meet these requirements before you attempt this configuration:
Knowledge of Lightweight Access Point Protocol (LWAPP).
●
Knowledge of how to configure basic parameters on the WLC.If you are a new user and have
not configured the WLC for basic operation, refer to the
not configured the WLC for basic operation, refer to the
section of Cisco Wireless LAN Controller Configuration Guide, Release 6.0.
●
Knowledge of how to configure Microsoft Windows 2000 DHCP Server and Domain Name
System (DNS) Server.
System (DNS) Server.
●
Components Used
The information in this document is based on these software and hardware versions: