Cisco Cisco Prime Infrastructure 3.0 Weißbuch

 

 

© 2015 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. 

Page 49 of 83 

The average time it takes an application server to respond to a request. This is the time between the client 
request arriving at the server and the first response packet being returned by the server. Increases in the 
server response time usually indicate problems with application server resources, such as the CPU, 
memory, disk, or I/O. 

The volume of bytes per second in each of the client, WAN, and server segments. 

The time between the client request and the final response packet from the server. Transaction time will 
vary with client uses and application types, as well as with network latency. Transaction time is a key 
indicator in monitoring client experiences and detecting application performance problems. 

RF profiles and groups are supported in Cisco Prime Infrastructure for both RF profile creation templates and AP 

group templates. If you use Cisco Prime Infrastructure to create the RF profiles through the creation of templates, 

this gives the administrator a simple way to create and apply templates consistently to groups of controllers. The 

process flow is the same as was previously discussed in the controller feature set with some minor but important 

differences. 

The process is the same as previously discussed in that you first create RF profiles, and then you apply the profiles 

through the AP groups. There are differences in how this is done from Cisco Prime Infrastructure and in the use of 

templates for deployment across the network. 

With Cisco Prime Infrastructure there are two ways that you can approach building or managing an RF profile. 

Choose Configure > Controllers, then click the IP address of the controller and choose 802.11 > RF Profiles in 

order to access profiles for an individual controller. 

 

The figure below displays all the RF profiles currently present on the chosen controller and allows you to make 

changes to profiles or AP group assignments. The same limitation as with the controller GUI is in effect in regard to 

a profile that is currently applied to an AP group. You have to disable the network or unassign the RF profile from 

the AP group.