Cisco Cisco Prime Infrastructure 3.0 Weißbuch
© 2015 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Page 76 of 83
You can search for “lan” (see the figure above) to see all the applicable templates as mentioned above. You can go
into any of the templates and deploy them based on what they do.
These two steps will allow you to deploy converged access devices using Cisco Prime Infrastructure.
Working with Converged Access Devices in Cisco Prime Infrastructure
TIP:
●
In order to refresh complete configuration from converged access devices (3850 and 5760) to Cisco Prime
Infrastructure, the recommended method is to use “Sync” from Device Work Center.
Infrastructure, the recommended method is to use “Sync” from Device Work Center.
●
When adding a 3850 and 5760, make sure that the SNMP Timeout value is at least 75 or more.
Wired clients connected through the selected switch/MA (Mobility Agent) can be viewed through Device > Detailed
Details > Clients > Currently Associated Clients (see the figure below).
Wireless clients terminating the device can be viewed from the scope of the access point to which they are
associated to. To view them, select Controller details and select the access point you want to view
(See figure below).