Cisco Cisco D9824 Advanced Multi Decryption Receiver Installationsanleitung
Setup Menu
78-4039426-01 Rev D
101
Setting
Mode Options
Description
Default
NITO
Pass, Drop, PwRC
Network Information
Table - Other
Table - Other
Pass
SDT
Pass, Drop, Regen, PwRC Service Description Table Pass
SDTO
Pass, Drop, PwRC
Service Description Table
- Other
- Other
Pass
BAT
Pass, Drop, PwRC
Bouquet Association
Table
Table
Pass
EIT
Pass, Drop
Event Information Table Pass
TDT
Pass, Drop
Time and Date Table
Pass
RST
Pass, Drop
Running Status Table
Pass
TOT
Pass, Drop
Time Offset Table
Pass
DIT
Pass, Drop
Discontinuity
Information Table
Information Table
Pass
SIT
Pass, Drop
Selection Information
Table
Table
Pass
ECM
Pass, Drop
Entitlement Control
Message
Message
Pass
EMM
Pass, Drop
Entitlement Management
Message
Message
Pass
DRT
Pass, Drop
Disaster Recovery Table Pass
CDT
Pass, Drop
Code Download Table
Pass
Note: The CDT is different from the other tables listed because the CDT is referred to within
the PMT, rather than outside the PMT. Select Pass to permit the output of CDTs following
the configured DPM PID map configuration and all other DPM constraints. If a DPM PID
map has not been configured for the CDT PID and the PE Act is set to Map, the CDT will still
not output. Select Drop to override the DPM PID map configuration for CDT PIDs and to
always drop all CDTs.
the PMT, rather than outside the PMT. Select Pass to permit the output of CDTs following
the configured DPM PID map configuration and all other DPM constraints. If a DPM PID
map has not been configured for the CDT PID and the PE Act is set to Map, the CDT will still
not output. Select Drop to override the DPM PID map configuration for CDT PIDs and to
always drop all CDTs.
Setting Up Digital Program Mapping (DPM)
To set up DPM:
1 Verify that you are receiving a valid signal and that you have set up the channels
1 Verify that you are receiving a valid signal and that you have set up the channels
that you want to pass, drop or map.
2 Go to the Setup: Outputs, TS Out: DPM: Global menu and select Resync All for
the selected ASI output. This copies the input services PIDs to the remapped
output service PIDs.
output service PIDs.
3 Go to Setup: Outputs: TS Out: DPM: ASI, and select the PE containing the
channel you want to configure.