Cisco Cisco D9824 Advanced Multi Decryption Receiver Installationsanleitung
Configuring Transport Stream Information
78-4039426-01 Rev D
165
Configuring Transport Stream Information
Configuring the ASI Output
1 From the user interface of the D9824, click Transport Stream > Transport
Handling > ASI Output. The ASI Output page is displayed.
Note: After you make any changes, a successfully updated (session open)
message appears. The changes are displayed, but not saved. You must click
Apply to save and apply the changes.
Note: After you make any changes, a successfully updated (session open)
message appears. The changes are displayed, but not saved. You must click
Apply to save and apply the changes.
Note: Any changes made to the ASI DPM values will automatically change the
Output Mode to Full DPM Control, unless the output mode is set to No Output.
Output Mode to Full DPM Control, unless the output mode is set to No Output.
2 Select the output Rate Control. The following table describes the affect each of
the settings has on the output bit rate:
Rate Control
Description
Auto
The output rate follows that set by the uplink. The output rate will
be the same as the input rate (including all null packets). This
means the output bit rate is determined automatically based on
the input source symbol rate and FEC value.
be the same as the input rate (including all null packets). This
means the output bit rate is determined automatically based on
the input source symbol rate and FEC value.
User
The output rate is specified by the User Rate field. It is determined
by the user setting regardless of the input source.
by the user setting regardless of the input source.