Cisco Cisco D9824 Advanced Multi Decryption Receiver Installationsanleitung
Chapter 4 Front Panel Operation
62
78-4039426-01 Rev D
Menu Item
Description
Parameters
InputIQ
Select the Input signal spectrum inversion
setting, which allows the operator to track and
select inverted and non-inverted digital
signals. This is normally used to automatically
reject or filter out unwanted signals.
setting, which allows the operator to track and
select inverted and non-inverted digital
signals. This is normally used to automatically
reject or filter out unwanted signals.
Auto, Normal, or
Opposite.
Opposite.
Auto - The signal is
tracked and inverted for
correct selection, as
required.
tracked and inverted for
correct selection, as
required.
Opposite - The signal is
always inverted.
always inverted.
Normal - The signal is not
inverted.
inverted.
NetID
Select the Network ID of the uplink signal the
receiver is to receive. The receiver's Network
ID must match the Network ID associated with
the transmitted signal.
receiver is to receive. The receiver's Network
ID must match the Network ID associated with
the transmitted signal.
1 to 65535. The default
value is 1.
value is 1.
LNB Power
Set the power output of RF1 to the external
LNB.
LNB.
Off, 13V, 18V, V-NIT, or
H-NIT.
H-NIT.
V-NIT and H-NIT will use
vertical and horizontal
polarity until it is
automatically read from
the NIT.
vertical and horizontal
polarity until it is
automatically read from
the NIT.
Note: Power will not be
applied to the LNB when
set to Off.
applied to the LNB when
set to Off.
22kHz
For dual band applications, select whether to
transmit the 22 kHz tone Local Oscillator
control signal of RF1.
transmit the 22 kHz tone Local Oscillator
control signal of RF1.
On, Off, or Auto.
Auto uses the crossover
frequency to determine if
the tone is transmitted.
frequency to determine if
the tone is transmitted.
Tune Mode
Custom
This menu is where you set up your custom properties. Select the channel to set up
and then edit it.
and then edit it.