Cisco Cisco Tunnel Terminating Gateway (TTG)
MAP Service Configuration Mode Commands
equipment-identity-register ▀
Command Line Interface Reference, StarOS Release 18 ▄
7241
equipment-identity-register
Defines the information relevant to the equipment-identity-register (EIR) used by the SGSN.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > MAP Service Configuration
configure > context context_name > map-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-map-service-service_name)#
Syntax
equipment-identity-register { isdn E.164_num | point code pt_code } [ check-imei-every-
n-events times| source-ssn ssn] [ include-imsi | map-include-imsi ]
n-events times| source-ssn ssn] [ include-imsi | map-include-imsi ]
no equipment-identity-register { isdn E.164_num | point codept_code }] [ include-imsi |
map-include-imsi ]
map-include-imsi ]
no
Deletes the EIR configuration.
isdn number
Enter the E.164 number of the EIR.
number:
must be a string of 1 to 15 digits.
point code
pt_code
Enter SS7 point code address of the EIR in dotted-decimal format according to variant settings:
ITU Range 0.0.1 to 7.255.7
ANSI Range 0.0.1 to 255.255.255
TTC Range 0.0.1 to 15.31.255
or a string of 1 to 11 characters
source-ssn ssn
Identifies the subsystem number (SSN) to be used.
ssn
must be an integer from 1 to 255.
check-imei-every-n-events times
Configures the frequency with which a ‘check IMEI’ message is sent to the EIR. When set, the SGSN skips
sending the ‘check IMEI’ message for the first N-1 where IMDI/IMEISV is received.
sending the ‘check IMEI’ message for the first N-1 where IMDI/IMEISV is received.
times :