Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Access Control Lists
Understanding ACLs ▀
Cisco ASR 5000 Series Session Control Manager Administration Guide ▄
OL-22952-01
Keyword/Variable
Description
Enables logging for packets meeting the criteria specified in the ACL.
I
MPORTANT
:
Logging is not supported for Policy ACLs (those applied to contexts).
The criteria to compare packets against as described in the section that follows.
Criteria
Each ACL consists of one or more rules specifying the criteria that packets will be compared against. The following
criteria are supported:
criteria are supported:
Any: Filters all packets
Source Address: Filter packets based on one or more source IP addresses
Source AoR: Filters packets based on the source address of record
Destination AoR: Filters packets based on the destination address of record
Each of the above criteria are described in detail in the sections that follow.
I
MPORTANT
:
The following sections contain basic ACL rule syntax information. Refer to the ACL Configuration
Mode Commands chapter of the Command Line Interface Reference for the full command syntax.
Any
The rule applies to all packets.
The following syntax is used when configuring rule criteria that applies to all packets:
Source Address
The rule applies to specific packets originating from a specific source IP address or a group of source IP addresses.
The following syntax is used when configuring rule criteria that apply to one or more source IP addresses:
Keyword/Variable
Description