Cisco Cisco ACE Application Control Engine Module Installationsanleitung
Americas Headquarters:
© 2012 Cisco Systems, Inc. All rights reserved.
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Installation Note, Cisco ACE Application Control
Engine ACE30 Module
Engine ACE30 Module
Released: October 2010
Revised: September 2012
Product Numbers: ACE30-MOD-K9
This document describes how to install the Cisco ACE Application Control Engine (ACE30) module.
The ACE30 module supports operation with software versions:
The ACE30 module supports operation with software versions:
•
A4(1.0) or later
•
A5(1.0) or later
You can install an ACE30 module in the following chassis:
•
Any Catalyst 6500E series switch or a Catalyst 6513 non-E chassis with IOS software version
12.2(33)SXI4 or later. See the
12.2(33)SXI4 or later. See the
section for information
about the various chassis and slot use.
•
Any Cisco 7600 or 7600S series router with IOS software release 15.0(1)S. See the
section for information about the various chassis and slot use.
Note
Be sure to upgrade the IOS software in your chassis as described above before you install an ACE30.
Note
ACE10-6500-K9, ACE20-MOD-K9 and ACE30-MOD-K9 modules can occupy the same chassis with a
maximum of four modules in one chassis. However, you cannot use an ACE10 or an ACE20 with an
ACE30 for redundancy.
maximum of four modules in one chassis. However, you cannot use an ACE10 or an ACE20 with an
ACE30 for redundancy.