Cisco Cisco ACE Application Control Engine Module Installationsanleitung
Americas Headquarters:
© 2008 Cisco Systems, Inc. All rights reserved.
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Cisco Application Control Engine Module
Installation Note
Installation Note
Product Numbers: ACE10-6500-K9, ACE20-MOD-K9
This document describes how to install the Cisco Application Control Engine (ACE) module. Unless
otherwise noted, ACE module refers to the ACE10-6500-K9 (ACE10) or ACE20-MOD-K9 (ACE20).
otherwise noted, ACE module refers to the ACE10-6500-K9 (ACE10) or ACE20-MOD-K9 (ACE20).
You can install an ACE10 or an ACE20 module in the following chassis:
•
A Catalyst 6500 series switch with IOS software version 12.2(18)SXF4 or later, or 12.2(33)SXH or
later. You can install the ACE10 or ACE20 in all Catalyst 6500 series models (both the E and non-E
switch chassis) as described in the
later. You can install the ACE10 or ACE20 in all Catalyst 6500 series models (both the E and non-E
switch chassis) as described in the
section.
•
A Cisco 7600 series router with IOS software release 12.2(18)SXF4 or 12.2(33)SRB or later. You
can install the ACE module in all Cisco 7600 series router models (both the S and non-S router
chassis).
can install the ACE module in all Cisco 7600 series router models (both the S and non-S router
chassis).
Note
ACE10-6500-K9, ACE20-MOD-K9 and ACE30-MOD-K9 modules can occupy the same chassis,
however, you cannot use an ACE10 or an ACE20 with an ACE30 for redundancy.
however, you cannot use an ACE10 or an ACE20 with an ACE30 for redundancy.
Contents
This document contains the following sections:
•
•
•
•
•
•
•
•
•