Cisco Cisco MGX-FRSM-HS2 B Serial Frame Service Module
31
Release Notes for Catalyst 6500 Series Switch SSL Services Module Software Release 3.x
OL-9138-05
Related Documentation
•
Exporting a PKCS12 file using FTP can take up to 20 minutes if a file with the same name exists on
the remote host. (CSCdy85233)
the remote host. (CSCdy85233)
•
If you enter the clear arp command on the SSLM, all the proxy services go into a “down” state, and
then go into an “up” state. (CSCdy77843)
then go into an “up” state. (CSCdy77843)
•
When you configure query mode, entering the no crypto pki certificate query command on the
running configuration does not stop the periodic polling for certificates. (CSCdy46075)
running configuration does not stop the periodic polling for certificates. (CSCdy46075)
•
On systems that are running Cisco IOS software and are configured with route processor redundancy
plus (RPR+) or stateful switchover (SSO), if you shut down the SSLM after a switchover (either
from the CLI or the SHUTDOWN button on the front panel), the module will not shut down and its
status will remain as “Other.”
plus (RPR+) or stateful switchover (SSO), if you shut down the SSLM after a switchover (either
from the CLI or the SHUTDOWN button on the front panel), the module will not shut down and its
status will remain as “Other.”
Workaround: Reset the module, and then shut down the module. (CSCee37656)
Resolved Caveats in Release 3.1(1)
There are no resolved caveats in SSL Services Module software release 3.1(1).
Related Documentation
For more detailed installation and configuration information, refer to the following publications:
•
Regulatory Compliance and Safety Information for the Catalyst 6500 Series Switches
•
Catalyst 6500 Series Content Switching Module Configuration Note
•
Catalyst 6500 Series Content Switching Module Command Reference
•
Catalyst 6500 Series Content Switching Module Installation and Verification Note
•
Catalyst 6500 Series Switch Installation Guide
•
Catalyst 6500 Series Switch Module Installation Guide
•
Catalyst 6500 Series Switch Software Configuration Guide
•
Catalyst 6500 Series Switch Command Reference
•
Catalyst 6500 Series System Message Guide
•
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide
•
Catalyst 6500 Series Switch Cisco IOS Command Reference
•
For information about MIBs, refer to this URL:
Cisco IOS Software Documentation Set
Cisco IOS Configuration Guides and Command References—Use these publications to help you
configure the Cisco IOS software that runs on the MSFC and on the MSM and ATM modules.
configure the Cisco IOS software that runs on the MSFC and on the MSM and ATM modules.