Cisco Cisco IP Phone 8841 Designanleitung
Cisco IP Phone 8861 and 8865 Wireless LAN Deployment Guide
197
Restoring Factory Defaults
The configuration of the Cisco IP Phone 8861 and 8865 can be reset to factory defaults by selecting Applications > Admin
settings > Reset settings > All settings.
settings > Reset settings > All settings.
A confirmation screen will appear where Reset must be selected to proceed with the factory data reset.
If the Cisco IP Phone 8861 or 8865 is not able to boot properly, a factory reset can also be initiated via the following procedure:
• Turn the phone off by disconnecting the power.
• Press and hold the # key, then power on the phone.
• Keep the # key held until the Mute LED turns off.
• Once the Mute LED turns off, release the # key.
• Then press 1 2 3 4 5 6 7 8 9 * 0 #.
• The Mute LED will turn on to indicate the factory reset sequence has been accepted.
• The Cisco IP Phone 8861 or 8865 will then continue the normal boot process and have the factory settings restored.
• Press and hold the # key, then power on the phone.
• Keep the # key held until the Mute LED turns off.
• Once the Mute LED turns off, release the # key.
• Then press 1 2 3 4 5 6 7 8 9 * 0 #.
• The Mute LED will turn on to indicate the factory reset sequence has been accepted.
• The Cisco IP Phone 8861 or 8865 will then continue the normal boot process and have the factory settings restored.
To boot the alternate image, perform the following procedure.
•
Turn the device off by disconnecting the power.
•
Press and hold the * key, then power on the phone.
•
Keep the * key held until the Mute LED turns off.
•
Once the Mute LED turns off, release the * key.
•
The Cisco IP Phone 8861 or 8865 will then boot using the alternate image.
Phone Webpages
Cisco IP Phone 8861 and 8865 information can be gathered remotely by accessing the phone’s standard or admin webpage
interfaces.
The standard webpage interface (
interfaces.
The standard webpage interface (
https://x.x.x.x
) contains read-only information regarding device information, network setup,
streaming statistics, device logs etc. To access the standard webpage interface, Web Access must be enabled in Cisco Unified
Communications Manager
The admin webpage interface (
Communications Manager
The admin webpage interface (
https://x.x.x.x:8443
) contains all of the info as the standard read-only page plus a few extra
configurable pages (i.e. Certificates, Date and time, and Phone restart). To access the admin webpage interface, Web Admin
must be enabled and Admin Password must be configured in Cisco Unified Communications Manager
must be enabled and Admin Password must be configured in Cisco Unified Communications Manager