Cisco Cisco Firepower Management Center 2000

FireSIGHT System Release Notes

Installing the Update

Sourcefire_3D_Device_3500-5.4.0-Restore.iso

Sourcefire_3D_Device_45100-5.4.0-Restore.iso

Sourcefire_3D_Device_6500-5.4.0-Restore.iso



for Series 3 managed devices:

Sourcefire_3D_Device_S3-5.4.0-763-Restore.iso



for virtual managed devices:

Sourcefire_3D_Device_Virtual64_VMWare-5.4.0-763.tar.gz



for Cisco NGIPS for Blue Coat X-Series devices:

SF3DSensor-5.4-763.cbi



for ASA FirePOWER modules:

asasfr-sys-5.4.0-763.pkg



for Cisco ASA with FirePOWER Services (ASA5506-X, ASA5506H-X, ASA5506W-X, ASA5508-X,  ASA5516-X, and 
the ISA 3000):

asasfr-5500X-boot-5.4.1-211.img

asafr-sys-5.4.1-211.pkg

: To install the ASA FirePOWER module Version 5.4.1.4 image on Cisco ASA with FirePOWER Services, see the 

Cisco ASA FirePOWER Module Quick Start Guide for more information on deploying and installing the module.

Installing the Update

Before you begin the update, you must thoroughly read and understand these release notes, especially 

To update Defense Centers running at least Version 5.4.1 to Version 5.4.1.4, ASA FirePOWER modules (ASA5506-X, 
ASA5506H-X, ASA5506W-X, ASA5508-X,  ASA5516-X, and the ISA 3000) running at least Version 5.4.1 to Version 
5.4.1.4, and managed devices and ASA FirePOWER modules (ASA5512-X, ASA5515-X, ASA5525-X, ASA5545-X, 
ASA5555-X, ASA5585-X-SSP-10, ASA5585-X-SSP-20, ASA5585-X-SSP-40, and ASA5585-X-SSP-60) running at 
least Version 5.4 of the FireSIGHT System to Version 5.4.0.5, see the guidelines and procedures outlined below:





 Do not reboot or shut down your appliances during the update until you see the login prompt. The system may 

appear inactive during the pre-checks portion of the update; this is expected behavior and does not require you to reboot 
or shut down your appliances.

Because the update process may affect traffic inspection, traffic flow, and link state, Cisco strongly recommends you 
perform the update in a maintenance window or at a time when the interruption will have the least impact on your 
deployment.

Use the Defense Center’s web interface to perform the update. Update the Defense Center first, then use it to update 
the devices it manages.