Cisco Cisco Firepower Management Center 2000 Fehlerbehebungsanleitung
Required Server Addresses for Proper AMP
Operations
Operations
Contents
Introduction
Prerequisites
Requirements
Components Used
Server Locations
North America
Europe
Static IP Addresses
Introduction
This document describes the servers that are required in order to enable the Cisco Advanced
Malware Protection (AMP) product to communicate and complete updates, lookups, and reports.
In order to complete the operations successfully, your firewall must allow connectivity from the
Connector to the required servers.
Malware Protection (AMP) product to communicate and complete updates, lookups, and reports.
In order to complete the operations successfully, your firewall must allow connectivity from the
Connector to the required servers.
Caution: All of the servers use a round-robin IP address schema for load balancing, fault-
tolerance, and uptime. Therefore, the IP addresses might change, and Cisco recommends
that the firewall be configured with CNAME instead of an IP address.
tolerance, and uptime. Therefore, the IP addresses might change, and Cisco recommends
that the firewall be configured with CNAME instead of an IP address.
Prerequisites
Requirements
Cisco recommends that you have knowledge of the Cisco Firepower Management Center (also
known as Defense Center) and these AMP products:
known as Defense Center) and these AMP products:
Cisco AMP Appliances
●
Cisco AMP for Firepower
●
Cisco AMP for Network Virtual Appliance
●
Cisco FireAMP Private Cloud Virtual Appliance
●
Cisco FireAMP for Endpoints
●
Components Used