Cisco Cisco Firepower Management Center 2000 Technisches Handbuch
Contents
Introduction
Prerequisite
Hardware Requirements
Procedures
Step 1: Backup the Current Configuration and Data
Step 2. Remove and Replace the Existing Storage Media
Step 3. Reconfigure the RAID Controller
Step 4. Reconfigure the Flash Storage Hardware
Step 5. Reinstall the operating system
Step 6. Restore the backup
Related Cisco Support Community Discussions
Introduction
The Cisco Unified Computing System (UCS) devices are configured with RAID hardware and
associated drives to configure a logical volume, which provides redundancy and presents the OS
with a single storage space. This document describes the steps to:
associated drives to configure a logical volume, which provides redundancy and presents the OS
with a single storage space. This document describes the steps to:
Back up the existing Sourcefire software installation
●
Remove and replace the existing storage media
●
Reconfigure the RAID controller
●
Reconfigure the storage hardware
●
Re-install the operating system
●
Restore the backup
●
Prerequisite
Hardware Requirements
The instruction in this document is applicable on Cisco FireSIGHT Management Center FS2000
and FS4000 models.
and FS4000 models.
This document is created using the devices that are in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live,
make sure that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live,
make sure that you understand the potential impact of any command.
Procedures
Step 1: Backup the Current Configuration and Data
1.1. Login to the web user interface (also known as GUI) for the UM.