Cisco Cisco Firepower Management Center 2000 Technisches Handbuch
Contents
Introduction
Prerequisites
Requirements
Components Used
Configuration
ACS 5.x configuration
Configuring Network Devices and Network Device Groups
Adding an Idenity Group in ACS
Adding a Local User to ACS
Configuring ACS Policy
FireSight Management Center Configuration
FireSight Manager System Policy Configuration
Enable External Authentication
Verification
Related Cisco Support Community Discussions
Introduction
This document describes the configuration steps required to integrate a Cisco FireSIGHT
Management Center (FMC) or Firepower Managed Device with Cisco Secure Access Control
System 5.x (ACS) for Remote Authentication Dial In User Service (RADIUS) user authentication.
Management Center (FMC) or Firepower Managed Device with Cisco Secure Access Control
System 5.x (ACS) for Remote Authentication Dial In User Service (RADIUS) user authentication.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
FireSIGHT System and Managed Device initial configuration via GUI and/or shell
●
Configuring authentication and authorization policies on ACS 5.x
●
Basic RADIUS knowledge
●
Components Used
The information in this document is based on these software and hardware versions:
Cisco Secure Access Control
●
Cisco FireSight Manager Center 5.4.1
●
Above versions are the latest versions available currently. The feature is supported on all ACS 5.x
versions and FMC 5.x versions.
versions and FMC 5.x versions.
The information in this document was created from the devices in a specific lab environment. All of
the devices used in this document started with a cleared (default) configuration. If your network is
the devices used in this document started with a cleared (default) configuration. If your network is