Cisco Cisco Firepower Management Center 2000 Installationsanleitung
3-15
Cisco NGIPS for Blue Coat X-Series Installation and Configuration Guide
Chapter 3 Installing Cisco NGIPS for Blue Coat X-Series
Installing Cisco NGIPS for Blue Coat X-Series
To load the software package:
Step 1
Log in to the X-Series platform as
root
:
CBS# unix su
When prompted, enter the password for your appliance.
Step 2
Copy the Cisco NGIPS for Blue Coat X-Series package
(SF3DSensor-5.4-#.cbi)
to the
/crossbeam/apps/archive
directory on the CPM, where
#
is the build number of Cisco NGIPS for Blue
Coat X-Series.
You can use either FTP or SCP to copy the file.
Installing Cisco NGIPS for Blue Coat X-Series on a VAP Group
After you have loaded the Cisco NGIPS for Blue Coat X-Series package on the CPM, install it onto the
appropriate VAP group.
appropriate VAP group.
Note
If you reconfigure your VAP group to use RAID, you must reload the VAP group. The symbolic link to
Cisco NGIPS for Blue Coat X-Series is not re-established until the RAID configuration is complete. This
can be as long as ten minutes.
Cisco NGIPS for Blue Coat X-Series is not re-established until the RAID configuration is complete. This
can be as long as ten minutes.
To install Cisco NGIPS for Blue Coat X-Series on a VAP group:
Step 1
Enter the following command to display the loaded applications:
CBS# show application
A list of applications appears. For example:
App ID : Sf3DSensor
Name : 3D Sensor
Version : 5.4
Release : 571
CBI Version : 1.6.0.0
Step 2
Install the software as follows:
CBS# application Sf3DSensor version version_number vap-group vap_group_name install
where
vap_group_name
is the name of the VAP group where you want to install the software and
version_number
is the version you want to install.
For example, to install Version 5.4 on a VAP group named
ABC
, enter the following:
CBS# application Sf3DSensor version 5.4 vap-group ABC install
A system check message appears, followed by the end user license agreement (EULA).
Step 3
Read the EULA, then type
y
to accept it.
Step 4
When prompted, enter the name of the management interface.
If you are following the example in this chapter, enter
mgmt
, which is the device name of the
mgmt
circuit
that you set up in
.
Step 5
When prompted, enter the IP address or host name of the Defense Center you will use to manage Cisco
NGIPS for Blue Coat X-Series.
NGIPS for Blue Coat X-Series.
Note that to use the host name of the Defense Center, the host name must be resolvable by DNS, and you
must have the IP address of at least one DNS server specified in your running configuration. In addition,
you must configure the DNS server for each VAP group by entering the following:
must have the IP address of at least one DNS server specified in your running configuration. In addition,
you must configure the DNS server for each VAP group by entering the following: