Manualsbrain.com
  1. Handbücher
  2. Marken
  3. Cisco
  4. Cisco MDS 9000 SAN-OS Software Release 1.0

Cisco Cisco MDS 9000 SAN-OS Software Release 1.0

Download
Seite von 14
S e n d   d o c u m e n t a t i o n   c o m m e n t s   t o   m d s f e e d b a c k - d o c @ c i s c o . c o m
8
Cisco MDS 9000 Family Release Notes for Storage Services Interface Image Release 5.0(4i)
OL-22148-03
  New Features
mount <file system>
New Features
This section describes the new features introduced in this release. For more information about the 
features listed, see the documentation set listed in the
.
The SSI Release 5.0(4i) image is compatible with the Cisco MDS NX-OS Release 5.0(4), 5.0(4a), and 
5.0(4b) images. 
Note
Cisco MDS SSI Release 5.0(4i) does not support the 32-port Storage Services Module (SSM), 
DS-X9032SSM. Refer the
 for additional 
information about Generation 1 modules that are not supported in Cisco MDS NX-OS Release 5.0(1a).
There are no new features in Cisco MDS SSI Release 5.0(4i).
Limitations
This sections lists limitations or restrictions associated with this release.
GUI Support Not Available for Target IO Timeout DVT Configuration
A target IO timeout for DVT can only be configured through the CLI. GUI support for this configuration 
is not available in Cisco MDS SSI Release 5.0(4i).
A Username Must be Less Than Eighteen Characters
If you enter a SANTap command with a username that is equal to or greater than 18 characters, the error 
message “remuser too long” displays, as shown in the following example:
switch# sh santap module 8 dvt
remuser too long
The show ivr command and the show zoneset act command complete correctly. 
This issue might be seen when you enter SANTap commands on the supervisor module to collect 
information from another module. 
To work around this issue, do one of the following:
•
Attach to the module and collect the information on the module itself.
•
Use a username with less than 18 characters.