Cisco Cisco IOS Software Release 12.4(22)XR

To configure the MIP FA, use the following commands in global and interface configuration modes:

Router(config)# router mobile

Enables MIP.

This and other MIP commands are used here to 
enable R-P signaling. They are required regardless 
of whether you implement SIP or MIP.

Router(config)# cdma pdsn send-agent-adv

Enables agent advertisements to be sent over a 
newly formed PPP session with an unknown user 
class that negotiates IPCP address options.

Router(config) interface virtual-template number

Creates a virtual template interface.

Router(config-if)# cdma pdsn mobile-advertisement-burst 

value] | [interval msec]}

Configures the number of FA advertisements to 
send and the interval between them when a new 
PPP session is created.

Router(config-if)# ip mobile foreign-service challenge 

value] | [window num]}

Configure the challenge timeout value and the 
number of valid recently-sent challenge values.

Router(config-if)# ip mobile foreign-service challenge 

Enables the FA to send mobile foreign challenge 
extensions (MFCE) and MN-AAA authentication 
extensions (MNAE) to the HA in registration 
requests.

Router(config-if)# ip mobile registration-lifetime seconds

Configures the maximum MIP registration 
lifetime.

Router(config-if)# ip mobile foreign-service [reverse-tunnel 

[mandatory]]

Enables MIP FA service on this interface.

Router(config-if)# ip mobile foreign-service registration

Sets the R bit in an Agent Advertisement.