Cisco Cisco IOS Software Release 12.2(27)SBC
680
Caveats for Cisco IOS Release 12.2(28)SB through 12.2(31)SB14
OL-9967-04 Rev. A1
Caveats
Conditions: This problem may occur after adding an ISG service policy to a Virtual-Template,
followed by the clear pppoe all command. New sessions start coming up.
followed by the clear pppoe all command. New sessions start coming up.
Workaround: There is no workaround.
•
CSCsr53027
Symptoms: A router crashes after a couple of switchovers in the Cisco 10000 iEdge area.
Conditions: This symptom is observed when ISG policies are configured at the router. A couple of
switchovers must be done.
switchovers must be done.
Workaround: There is no workaround.
Further Problem Description: This problem occurs due to the virtual access numbers (if_number)
equal to -1.
equal to -1.
•
CSCsr57376
Symptoms: A router crashes due to a TLB exception.
Conditions: This symptom is seen while deleting the class-default class map in a MQC policy map
that is applied to thousands of PPPoX sessions.
that is applied to thousands of PPPoX sessions.
Workaround: There is no workaround.
•
CSCsr65585
Symptoms: Features intermittently fail to be installed for users.
Conditions: This symptom occurs under the following conditions:
–
Running ISG
–
Having 1000s of DHCP initiated subscribers using the iEdge features, for example L4R, PBHK,
etc.
etc.
–
Applicable to Cisco 10000 series router only
Workaround: Reload, or if possible switchover to other PRE.
•
CSCsr68082
Symptoms: A router crashes when unconfiguring multipoint ATM subinterface that is configured to
bring up PPPoA sessions.
bring up PPPoA sessions.
Conditions: This symptom is seen when unconfiguring multipoint ATM subinterface that is
configured to bring up PPPoA.
configured to bring up PPPoA.
Workaround: There is no workaround.
•
CSCsr73116
Symptoms: A Cisco 10000 series router (PRE3) crashes on active and standby PRE3 with the
following error:
following error:
PRE3 crash: COB3_FCPU_LQ_OFF_ERR: Low Priority Offset Error
Conditions: This symptom is observed on a Cisco 10000 series router that is running Cisco IOS
Release 12.2(31)SB10.
Release 12.2(31)SB10.
Workaround: There is no workaround.