Cisco Cisco 4100 Series Wireless LAN Controller Technische Referenzen

 

config port power

To change Power over Ethernet (PoE) settings for a single port or all Cisco Wireless LAN Controller 
ports, use the config port power command. NOT ALL APs are PoE (802.3af) compatible! If you are using 
Third-Party access points, refer to your user documentation to determine compatibility. Enabling PoE to 
non-compatible APs can result in severe equipment damage including fire!

config

Configure parameters.

port

Port parameters

power

PoE mode

[<port>/all] 

Individual port number or all ports

[enable/disable]

Port state

Enabled

To disable PoE on port 8:
>config port power 8 disable

To enable PoE on all ports:
>config port power all enable

show port

config prompt

To change the CLI system prompt, use the config prompt command.
This command can be used any time the CLI interface is active.

Because the system prompt is a user-defined variable, it is omitted from the rest of this documentation.

config

Configure parameters.

prompt

CLI system prompt, up to 31 alphanumeric 
characters.

<system prompt>

New CLI system prompt, in double quotes. 

The system prompt is configured using the startup wizard.

(old CLI prompt >

Type here>

(none)

config qos queue_length

To configure the Quality of Service parameter, use the config qos command.

config qos

Command action.

queue_length 

Configure QoS queue length.

bronze/silver/gold/

Level of quality of service: Background, Best Effort,

<length>

Queue length.

N/A