Cisco Cisco 5760 Wireless LAN Controller Installationsanleitung
25
Cisco 5700 Series Wireless Controller Installation Guide
OL-28544-02
Using the Startup Wizard
Step 3
Enter the enable secret password. This password is used to protect access to privileged EXEC and
configuration modes. This password, after entered, becomes encrypted.
configuration modes. This password, after entered, becomes encrypted.
Step 4
Enter the enable password. This password is used when you do not specify an enable secret password
(for some older software versions, and some boot images).
(for some older software versions, and some boot images).
Step 5
Enter the virtual terminal password. This password is used to protect access to the controller over a
network interface.
network interface.
Step 6
If you want the controller to receive its time setting from an external Network Time Protocol (NTP)
server when it powers up, enter yes to configure an NTP server. Otherwise, enter no.
server when it powers up, enter yes to configure an NTP server. Otherwise, enter no.
•
If you enter yes:
a.
Enter the NTP server address.
b.
Enter the polling interval (between 16 and 131072 secs, which is a power of 2).
•
If you enter no:
a.
Enter yes to configure the system time.
b.
Enter the current date in MM/DD/YY format and the current time in HH:MM:SS format.
Step 7
To configure the wireless network, enter yes.
Step 8
If desired, enter the name of the mobility group to which you want the controller to belong.
Step 9
Enter the code for the country in which the controller will be used.
Step 10
When prompted to configure the SNMP network management, enter yes or no.
•
If you enter yes, enter the Community String.
•
If you enter no, proceed to the next step.
Step 11
Perform management network configuration. The current interface summary appears.
For an example:
For an example:
Interface IP-Address OK? Method Status Protocol
Vlan1 unassigned YES NVRAM administratively down down
GigabitEthernet0/0 unassigned YES unset administratively down down
Te1/0/1 unassigned YES unset up up
Te1/0/2 unassigned YES unset down down
Te1/0/3 unassigned YES unset down down
Te1/0/4 unassigned YES unset down down
Te1/0/5 unassigned YES unset down down
Te1/0/6 unassigned YES unset down down
a.
Enter the interface name used to connect to the management network from the above summary. In
this example, the interface name is GigabitEthernet0/0.
this example, the interface name is GigabitEthernet0/0.
b.
To configure the IP address on the interface, enter yes.
c.
Enter the IP address for the interface.
d.
Enter the subnet mask for the interface.
Step 12
Configure the wireless management interface.
The wireless management interface must be configured at startup.
a.
Enter the VLAN number for the wireless management interface.
b.
Enter the IP address for the interface.
c.
Enter the IP address mask for the interface.