Cisco Cisco 4402 Wireless LAN Controller
R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
4
Release Notes for Cisco Wireless LAN Controllers and Lightweight Access Points for Release 3.2.210.0
OL-xxxxx-xx
New and Changed Information
Support for Per-WLAN ACLs
Access control lists (ACLs) can be applied to WLANs as well as interfaces. ACLs are applied in the
following order:
following order:
•
Interface ACLs
•
WLAN ACLs
•
Client ACLs (from the AAA server)
You can apply an ACL to a WLAN only through the controller CLI. To do so, enter this command:
config wlan acl
Support for Reusable Static WEP Key Indices
The same static WEP key index can be configured for multiple WLANs.
Power-over-Ethernet Parameters
Controller software supports power-over-Ethernet (PoE), also known as inline power, parameters for the
AP1131 and the AP1242 in the controller GUI. To access these parameters, click Wireless and then the
Detail link of the desired access point. The new parameters appear on the All APs > Details page under
Power Over Ethernet Settings.
AP1131 and the AP1242 in the controller GUI. To access these parameters, click Wireless and then the
Detail link of the desired access point. The new parameters appear on the All APs > Details page under
Power Over Ethernet Settings.
These parameters enable you to configure inline power and power injector settings for an AP1131 or
AP1242:
AP1242:
•
Pre-Standard State—Check this check box if the access point is being powered by a high-power
Cisco switch. These switches provide more than the traditional 6 Watts of power but do not support
the intelligent power management (IPM) feature. These switches include:
Cisco switch. These switches provide more than the traditional 6 Watts of power but do not support
the intelligent power management (IPM) feature. These switches include:
–
WS-C3550, WS-C3560, WS-C3750,
–
C1880,
–
2600, 2610, 2611, 2621, 2650, 2651,
–
2610XM, 2611XM, 2621XM, 2650XM, 2651XM, 2691,
–
2811, 2821, 2851,
–
3620, 3631-telco, 3640, 3660,
–
3725, 3745,
–
3825, and 3845.
Do not check this check box if power is being provided by a power injector or by a switch not on
this list.
this list.
•
Power Injector State—Check this check box to enable the power injector state for an access point.
This parameter is required if the attached switch does not support IPM and a power injector is being
used. This parameter is not required if the attached switch supports IPM.
This parameter is required if the attached switch does not support IPM and a power injector is being
used. This parameter is not required if the attached switch supports IPM.