Cisco Cisco 5508 Wireless Controller Designanleitung
1-30
Book Title
OL-xxxxx-xx
Chapter 1 Cisco Adaptive wIPS Management Deployment Guide, Release 8.0
Cisco Adaptive wIPS Introduction
b.
Change AP Mode to Local.
c.
Change AP Sub Mode to WIPS.
d.
Click Save at the bottom of the page.
e.
Click OK when prompted to reboot the AP.
Repeat this for each AP that is configured to local mode with wIPS.
Configuring Access Points to wIPS Monitor Mode
Any indoor access point (AP) can be configured to wIPS monitor mode.
To configure APs for wIPS monitor mode:
Step 1
Configure the Access Point to Monitor Mode:
a.
Enter the AP configuration menu in PI via Operate > Device Group> Device Type> Unified AP
and click on the Access Point’s name, then Configuration
and click on the Access Point’s name, then Configuration