Cisco Cisco Email Security Appliance C160 Technische Referenzen
3-110
Cisco AsyncOS 8.5.6 CLI Reference Guide
Chapter 3 The Commands: Reference Examples
General Management/Administration/Troubleshooting
reboot
Description
Restart the appliance.
Usage
Commit: This command does not require a ‘commit’.
Cluster Management: This command is restricted to machine mode.
Batch Command: This command does not support a batch format.
Example
remotepower
Description
Configure the ability to remotely reset power to the appliance chassis using a third-party Intelligent
Platform Management Interface (IPMI) tool that supports version 2.0. The following IPMI commands
are supported:
Platform Management Interface (IPMI) tool that supports version 2.0. The following IPMI commands
are supported:
status, on, off, cycle, reset, diag, soft
.
This command runs only on the following hardware: C380 and C680, M380 and M680, and S380 and
S680.
S680.
You will need a dedicated IPv4 address for the Remote Power Management interface. This interface is
configurable only via the
configurable only via the
remotepower
command; it cannot be configured using the
ipconfig
command.
The username and password that you specify with this command will be required in order to remotely
reset appliance power.
reset appliance power.
Table 3-52
reboot
mail3.example.com> reboot
Enter the number of seconds to wait before abruptly closing connections.
[30]>
Waiting for listeners to exit...
Receiving suspended.
Waiting for outgoing deliveries to finish...
Mail delivery suspended.