Cisco Cisco Email Security Appliance C170 Betriebsanweisung
A-2
Cisco AsyncOS 8.5 for Email User Guide
Appendix A FTP, SSH, SCP, and Telnet Access
Configuring FTP Access to the Email Security Appliance
For email delivery and Virtual Gateways, each IP interface acts as one Virtual Gateway address with a
specific IP address and hostname. You can also “join” interfaces into distinct groups (via the CLI), and
the system will cycle through these groups when delivering email.
specific IP address and hostname. You can also “join” interfaces into distinct groups (via the CLI), and
the system will cycle through these groups when delivering email.
Joining or grouping Virtual Gateways is useful for load-balancing large email campaigns across several
interfaces. You can also create VLANs, and configure them just as you would any other interface (via
the CLI). For more information, see
interfaces. You can also create VLANs, and configure them just as you would any other interface (via
the CLI). For more information, see
Configuring FTP Access to the Email Security Appliance
Procedure
Step 1
Use the Network > IP Interfaces page or the
interfaceconfig
command to enable FTP access for the
interface.
WARNING: By disabling services via the
interfaceconfig
command, you have the potential to
disconnect yourself from the CLI, depending on how you are connected to the appliance. Do not disable
services with this command if you are not able to reconnect to the appliance using another protocol, the
Serial interface, or the default settings on the Management port.
In this example, the Management interface is edited to enable FTP access on port 21 (the default
port):
port):
Figure A-1
Edit IP Interface Page
Note
Remember to
commit
your changes before moving on to the next step.
Step 2
Access the interface via FTP. Ensure you are using the correct IP address for the interface. For example:
$ ftp 192.168.42.42