Cisco Cisco Aironet 340 Ethernet Bridges Betriebsanweisung
B-5
Ipdisplay - Display the IP address filters
Add - Add a node address filter
Remove - Remove a node address filter
Protocols - Protocol filters
Default - Default action
Unicast - Filter unicast packets
Display - Display the protocol filters
Add - Add a protocol filter
Remove - Remove a protocol filter
Length - Length of packet data to log
Monitor - Protocol monitoring enabled
Show - Show forwarded protocol list
Clear - Clear forwarded protocol list
Direction - Packet direction affected by filters
Logs - Alarm and log control
History - Log and alarm history
Clear - Clear the history buffer
Printlevel - Type of logs to print
Loglevel - Type of logs to save
Ledlevel - Type of logs to light status led
Statistics - Set alarms on statistics
Network - Log network roaming
Bnodelog - Log backbone node changes
Snmp - Set-up SNMP traps
Trapdest - IP destination for SNMP traps
Trapcomm - Community for SNMP traps
Loglevel - Type of logs to cause a trap
Authtrap - Enable authentication failure trap
Syslog - Unix syslogd address
Syslevel - Type of logs to send to syslog
Facility - Syslog facility number to send
Rcvsyslog - Enable reception of syslogmessages
Diagnostics - Maintenance and testing commands
Network - Network connection commands
Connect - Start telnet session
Escape - Connection escape sequence
Ping - Send an IP PING packet
Find - Flash LEDs to find unit
Linktests - Test the radio link
Strength - Run a signal strength test
Carrier - Carrier busy statistics
Align - Antenna alignment test
Multicast - Run a multicast echo test
Unicast - Run a unicast echo test
Remote - Run a remote echo test